gefran AGL50-EV Series - Page 51

AGL50-EV 51
Code
PARAMETER PICK LIST
Def. Min Max Unit Variat. IPA
Name DESCRIPTION Selection Description
I.311 An out 2 offset Analog output 2 offset 0 -9.99 9.99 0.01 138
I.312 An out 2 gain Analog output 2 gain 1 -9.99 9.99 0.01 139
I.313 An out 2 lter Time constant of output lter 0 0 2.5 sec 0.01 140
I.350 Exp an out 1 cfg
Expansion Analog Output 1 conguration
(on Exp. board)
As for I.300 3 0 22 141
I.351 Exp AnOut 1 offs Expansion Analog Output 1 offset 0 -9.99 9.99 0.01 142
I.352 Exp AnOut 1 gain Expansion Analog Output 1 gain 1 -9.99 9.99 0.01 143
I.353 Exp AnOut 1 lt Time constant of output lter 0 0 2.5 sec 0.01 144
I.400 Inp by serial en Virtual Digital enabling 0 0 255 145
I.410 Exp in by ser en
Expansion Virtual Digital
Inputs enabling
0 0 15 146
I.420 Out by serial en Virtual Digital Outputs setting enabling 0 0 15 147
I.430 Exp OutBySer en Expansion Virtual Digital Outputs enabling 0 0 3 148
I.450 An out by ser en Virtual Analog Outputs enabling 0 0 255 149
I.500 Encoder enable Enabling of the encoder measure [0] Disable
Encoder measure
disabled.
0 0 1 150
[1] Enable
Encoder measure
enabled.
I.501 Encoder ppr Encoder nameplate pulses per revolution 1024 1 9999 151
I.502 Enc channels cfg Encoder channels conguration [0] One Channel A (K1) encoder channel 1 0 1 152
[1] Two Channels
A and B (K1 and K2)
encoder channels
I.503 Enc spd mul fact
Multiplier factor of the encoder pulses, set
in the I.501
1 0.01 99.99 153
I.504 Enc update time Encoder pulses sampling time [0] 1ms 0 0 5 154
[1] 4ms
[2] 16ms
[3] 0.25s
[4] 1s
[5] 5s
I.505 Enc power supply Encoder power supply level [0] 5.2V 0 0 3 181
[1] 5.6V
[2] 8.3V
[3] 8.7V
I.506 Enc fault enable Enable ENC alarm, Encoder cable break [0] Disable Encoder alarm disabled 0 0 1 197
[1] Enable Encoder alarm enabled
I.600 Serial link cfg Serial line conguration protocol & mode
Type(DataBit) Parity
(StopBit)
4 0 5 0.1 155
[0] FoxLink 7E1
FoxLink 7E1 (7) Even
(1 )
[1] FoxLink 701 FoxLink 7O1 (7) Odd (1)
[2] FoxLink 7N2
FoxLink 7N2 (7) None
(2)
[3] FoxLink 8N1
FoxLink 7O1 (8) None
(1)
[4] ModBus 8N1
Modbus 8N1 (8) None
(1)
[5] JBus 8N1 Jbus 8N1 (8) None (1)
I.601 Serial link bps Serial line baudrate [0] 600 baud 600 baud rate 4 0 6 156
[1] 1200 baud 1200 baud rate
[2] 2400 baud 2400 baud rate
[3] 4800 baud 4800 baud rate
[4] 9600 baud 9600 baud rate
[5] 19200 baud 19200 baud rate
[6] 38400 baud 38400 baud rate
I.602 Device address Serial line address of the drive 1 0 99 1 157