Geller TL-550 - Setting PASSWORD

Flag 11
Enter 0 or 1 for each bit (N1 to N8), and press
ENTER
each time to fix your decision.
Bit#: Options: Function:
N1
0 Print the grand total as a net sales amount on the Z report: the report which is issued after
resetting the sales.
1 Print the grand total as a gross sales amount on the Z report: the report which is issued after
resetting the sales.
N2
0Print the number of transactions on the hourly report.
1 Print the number of items on the hourly report.
N3
0 Enable pressing just the #/ST Key.
1Disable pressing just the #/ST Key.
N4
0 Enable pressing the #/ST Key immediately after entering numeric Keys even not in ringing up.
1Disable pressing the #/ST Key immediately after entering numeric Keys except in ringing up.
N5
0 Enable [-], [-%] key operation in register mode.
1Disable [-], [-%] key operation in register mode.
N6
0 Enable RA/PO operation in register mode.
1Disable RA/PO operation in register mode.
N7
0 2nd Receipt issue by TOTL key depends on N8.
1 2nd Receipt issue by TOTL key is prohibited regardless of the Receipt On/Off mode.
N8
0 2nd Receipt issue by TOTL key is enabled when the register is in Receipt Off mode.
1 2nd Receipt issue by TOTL key is enabled regardless of the Receipt On/Off mode.
To move to next Flag, just press
PAGE UP
. If you wish to skip to Flag 23 directly, enter 23
and
DSGN
.
To return to PROGRAM 2 MENU, just press
ESC
.
Flag 12
Enter 0 or 1 for each bit (N1 to N8), and press
ENTER
each time to fix your decision.
Bit#: Options: Function:
N1
0Print item by item in registration when Receipt On is set by the ID key.
1 Print after a finalization key (CASH/TEND, CHKS or CHRG key) is pressed in registration
when Receipt On is set by the ID key.
N2
0Disable the registration by another clerk’s operation while the primary clerk’s registration is
interrupted.
1 Enable the registration by another clerk’s operation while the primary clerk’s registration is
interrupted and kept in memory as HOLD.
N3
0Print the consecutive number on reports.
1 Do not print the consecutive number on reports.
N4
0Print hourly total in the X/Z reports by pressing the X key.
1Print daily total in the X/Z reports by pressing the X key.
N5
0 Do not reset the transaction number (consecutive number) after issuing the Z report.
1Reset the transaction number (consecutive number) after issuing the Z report.
N6
0 Change the “Department 11 to 20 entry mode” back to the “Department 1 to 10 entry mode”
when the current sales transaction is finished.
1 Stay in the “Department 11 to 20 entry mode” until the
DEPT/SHFT
Keys pressed again to
change back to the “Department 1 to 10 entry mode”.
N7
0 Do not reset the clerk password each time the position of the Control Lock is changed.
1 Reset the clerk password each time the position of the Control Lock is changed.
N8
0 Do not reset the clerk password after each sales transaction is finished.
1 Reset the clerk password after each sales transaction is finished.
To move to next Flag, just press
PAGE UP
. If you wish to skip to Flag 23 directly, enter 23
and
DSGN
.
To return to PROGRAM 2 MENU, just press
ESC
.
5. P2 programming
32
1
2
3
4
5
6
7
8
9
10
11
12