GEM 1435 ePos - Page 47

www.gemu-group.com 47 / 71 GEMÜ 1435 ePos
Pos Ctrl Out:
Displays the speed at which the valve should move.
NOTICE
Excessive system deviation
▶ If the deviation is too large, this is shown by a dot on the left-hand side or right-hand side of the display. In this case, the
valve must move at maximum speed.
Relay:
Displays the current position of internal relays A1, A2 and Error (relay switched = ).
17.2.3.2.2 Activating or deactivating user access
I / O Status
1.1
Service
1
SetFunction
3
SetCalibration
4
Communication
5
SetBasics
2
SETUP
Login
1.2
The configuration level of the product is protected in certain areas by various codes against unauthorised changing of paramet-
ers.
The operating levels are pre-defined and intended for three different user groups:
- Level 3: All customer settings available and alterable, including the option of defining the physical (e.g. system installer, oper-
ator, manager).
- Level 2. Reduced customer settings available and alterable, specially reduced to the most important parameters for fault
clearance. Option of adaptation within the set physical (e.g. system manager or machine manager).
- Level 1. Customer settings are not available or alterable, only status information is shown.
All menu items are marked by symbols indicating their write and read protection.
Configuration
level
Display Function Value range Default setting Active level
Read Edit
Mode Select operating
mode
AUTO
MAN
AUTO 0 3
1 Service New Code: 1 Lowest priority re-
leased
0…10000 0 1 1
The following Active Level codes apply:
Active
Level 0
No release required for reading and writing
Active
Level 1
The lowest priority release, code 1, is required for reading and writing
Active
Level 2
The medium priority release, code 2, is required for reading and writing
Active
Level 3
The highest priority release, code 3, is required for reading and writing (default state)
17 System mode ADVANCED