Gemu 1436 cPos - Initialisation Process; Menu structure automatic and manual initialisation

15 / 66
1436 cPos
9.2.3 Menu structure automatic and manual initialisation
Init Valve Man
r3w3
2 x betätigen
CtrlFn Auto
goClose XX.X% goOpen XX.X%
adjTime X.X: X.X
findCoefficent
Return
Zurück zu InitValve
goClose XX.X% Valid? OK
OK
ESC
goOpen XX.X%
Valid? OK ESC
adjTime X.X: X.X
findCoeff X.X %
ESC ESC
Init Pilot
Init Pilot
ESC
Auto NC
Auto NO
Auto DA
Auto NC B
Auto NO B
Auto DNO
DNO
NC
NO
DA
Boost NC
Boost NO
Automatische Initialisierung
ManuelelInitialisierung
manuellautomatisch
A: w XX.X: x XX.X
SETUP
Mode Auto
Manual
OFF
OK
OK
The GEMÜ 1436 cPos positioner is ready for operation and reacts to the externally specified set value. It must be activated separately for the "process controller" option (see chapter 15.2).
The GEMÜ 1436 cPos positioner is ready for operation and reacts to the externally specified set value. It must be activated separately for the "process controller" option (see chapter 15.2).
Valve can be opened and closed
= Automatic initialisation
automatic manual
Manual initialisation
Automatic initialisation
Press twice
Switching message after connecting the supply voltage. without factory setting
Press twice