Gemu 1436 cPos - Quick commissioning of the GEMÜ 1436 cPos; Automatic fast initialisation

2 / 66
1436 cPos
Quick commissioning of the GEMÜ 1436 cPos:
Prerequisites:
● Mounted to the valve.
● Air supply, max. 7bar, connected.
● 24 V DC supply voltage connected.
● Set value and actual value signals need not be connected.
● For correct commissioning proceed as described in the following ow chart:
Automatic fast initialisation
The initialisation can alternatively be started via the
parameter "Init Valve".
This message is
displayed for five
seconds and then
deleted automati-
cally.
It can be switched
off within the five
seconds by pres-
sing the
+
key.
StartInitValve
3 Sekunden drücken
OK ESC
Init Valve
ESC
OK
The GEMÜ 1436 cPos positioner
is ready for operation and reacts
to the externally specified set
value.
It must be activated separately
for the "process controller" opti-
on (see chapter 15.2).
Valve can be
opened and
closed
Switching message after
connecting the supply
voltage.
without factory setting
= Automatic
initialisation
Press 3 seconds