47
IGNITION SYSTEM
The ignition system consists of a flywheel magneto, a CDI&Ignition coil unit and a spark plug.
As the rotor tatates, an AC current is induced in the coil. Then current induced in the ○,
A
direction charges up
the capacitor.
As the rotor rotates further, the current is induced in the reverse direction (dirction○,
B
). the current causes a
voltage applied through the ground to the gate of SCR.
As the SCR conducts, the energy which has been charged in the capacitor is instantaneously discharged
through the primary winding of the ignition coil.
CDI UNIT AND IGNITION COIL INSPECTION
CHECKING WITH ELECTRO TESTER
Connect the CDI test lead to the coil”s primary connector.
Connect the high tension leads, red○,
+
lead to the spark plug
cord and the black○,
—
lead to the black lead of the test lead.
z Set the test selector knob to “P.E.I”.
z Connect the power lead to the appropriate AC source.
z Switch the power on.
Switch Black
red
CDI test lead
MAGNETO
CDI&Ignition coil unit
Spark plug
To Next Page
Loading...
Need help?
General
