4
PRECAUTIONS AND GENERAL INSTRUCTIONS
• Correctly abide by the following items when disassembling and assembling scooter:
• Don’t run engine indoors without ventilation;
• Be sure to replace new bushings, circlips, O-rings and cotter pins with new ones；
CAUTION
• It is forbidden to use the circlip removed from shaft again, only use new one；
• Be very carefull to install new circlip for fear that the end hatch of circlip exceeds required sliding surface
for shaft；
• After installing circlip, inspect whether it has been completely clipped into the groove.
• Fix bigger diameter bolt first when tightening cylinder head or cylinder, and tighten to specified torque
gradually from inside to outside at diagonal order.
• Use special tools for some special requirements；
• Use original components and recommended engine oil；
• Keep each other’s safety when several persons do；
• Inspect looseness and operating state of components after reassembling them.；
• Take high care of gasoline, which is explosive, and never use gasoline as lotion.
The words like warning, notice, note may turn out incessantly in the manual, which means:
WARNING The personal safety of the rider may be involved. Disregarding the information could result in injury
to the rider.
CAUTION These instructions point out special service procedures or precautions that must be followed to
avoid damaging the machine.
NOTE it provides some special information, which keeps maintenance easier and important instructions
clearer..
REPLACEMENT COMPONENTS
Be sure to use genuine GENERIC components or their equivalent.. Genuine GENERIC components are high
quality parts which are designed specially for your vehicle.
CAUTION
Damage to the scooter may result from use of replacement components which are not Equivalent in quality to
genuine GENERIC parts, and it can lead to performance problems.
To Next Page
Loading...
Need help?
General
