Generic XOR 125 - REAR WHEEL AND BRAKE REASSEMBLY; Rear Wheel Reassembly

81
REASSEMBLY AND REMOUNTING
Reassemble and remount the rear wheel and brake in the
reverse of removal, and also carry out the following steps:
□ Turn the punched mark  on the camshaft to the rear
axle
shaft side.
□ Install the protrusion  of indicator plate to the groove  of
Camshaft.
□ When installing the brake cam shaft, aligh the groove  of camshaft with
the slit  of on cam shaft.
□ When installing brake shoes, be sure to daub camshaft with
adequate grease.
CAUTION:
Be careful not to daub the camshaft with too much grease.
If grease gets on the lining, brake effectiveness will be lost.