1-41
01
Using Plug n charge (PnC) (For 
Europe)
When charging with a DC charger, you 
can use the PnC function to charge your 
electric vehicle quickly and easily.
Turning PnC on and off 
 CAUTION
If you do not have a PnC contract, turn 
off the PnC function. If the function is 
turned on, problems with the charging 
process may occur.
On the infotainment system, select ‘EV 
Settings → Plug n charge’.
•
  Select the check box to turn the PnC 
function on.
•  Uncheck the check box to turn the 
PnC function off.
Renewing the PnC
If the PnC does not proceed or fails 
during the process, check the expiration 
and renewal status of the contract 
certificate. 
 CAUTION
•  The PnC will not proceed if the 
certificate has expired.
•
  Turn off the PnC function and use an 
external payment method until you 
check the certificate status. If the 
PnC fails more than two times, the 
payment method is forcibly switched 
to an external payment method from 
the third attempt.
 Information
•  To reset and enable PnC again after the 
payment method is forcibly switched 
to an external payment method, follow 
one of the instructions below:
 - Charge once using an external 
payment method. PnC will be 
available from the next charge.
 - Disconnect the charging plug, close 
the charging door, and wait at least 
one minute with the vehicle on.
 - Use another charger that is PnC 
enabled. 
If the contract certificate for the PnC 
has expired or withdrawn, follow the 
instructions below:
1.
  Make a new contract to issue or renew 
the certificate.
2.
  Connect the charging plug and try 
PnC once.
 - The charger will display the 
expiration and withdrawal status of 
the certificate and the charging will 
be failed.
3.
  Disconnect and reconnect the 
charging plug and retry charging.
 - The newly contracted certificate 
will be installed and charging will 
proceed normally.