Genesis GV60 - Page 548

7-121
07
Highway Lane Change Assist (if
equipped)
Display and control
You can see the status of the Highway
Lane Change Assist function operation
in the Driving Assist view on the cluster.
Refer to "View modes" section in chapter
4.
Highway Lane Change Assist function
will be displayed as below depending on
the status of the function.
 Ready/OperatingReady/Operating  Standby/CanceledStandby/Canceled
OJWEV071298LOJWEV071298L OJWEV072039LOJWEV072039L
(1) Highway Lane Change Assist
indicator
•
Green on: Ready state
•
Green blink: Operating state
•
Grey on: Standby state
•
White blink: Canceled state
(display only a certain time)
(2) Green lane line
The green lane line is displayed when
the function starts operating, and until
the vehicle steps on the lane line.
(3)
Green arrow and shade
The green arrow is displayed when a
certain amount of time has passed
after the function has started
operating, and until the lane change
has completed.
(4)
Message
•
Message is displayed when the
function does not operate even
though the turn signal lever is used.
•
Message is displayed when
the function is canceled while
operating.
 Type AType A  Type BType B
OJWEV071270LOJWEV071270L ORG3EV071200LORG3EV071200L

Highway Lane Change Assist function
will turn on when the following
conditions are satisfied.
•
The Driving Assist button or Lane
Driving Assist button is used to turn
on Highway Driving Assist.
•
The OK button is pressed on the
steering wheel while a message
asking to use Highway Lane Change
Assist is displayed on the cluster.