7-122
Driver assistance system
operate
While Highway Lane Change Assist
function is on, the function will be
ready to operate when all the following
conditions are satisfied:
•
Highway Driving Assist is operating
•
Lane Following Assist is operating
•
A vehicle in the rear area of your
vehicle is detected more than once
after the vehicle is turned on
•
Your vehicle speed is above 30 km/h
(18 mph)
• When your vehicle is between 30-
80 km/h (18-50 mph), a vehicle is
detected in the rear area of your
vehicle’s left and right side lanes,
and there is no risk of collision when
changing a lane
•
Hands-off warning is not displayed on
the cluster
•
Hazard warning flasher is off
Information
• While Lane Change Assist function
is turned on (indicator on), Lane
Following Assist will not cancel even
if the turn signal indicator or hazard
warning flasher is operating.
•
Lane Change Assist function turns
off automatically when driven in the
following road conditions:
- One driving lane
- A road with a intersection or
crosswalk ahead
- A road with no structure, such as a
medium strip, guardrails, etc.
- There is a pedestrian or cyclist on the
road ahead
•
When the function is in the ready state,
and vehicle speed is below 25 km/h
(15.5 mph), the function will change to
the standby state.
•
When your vehicle is between 30-75
km/h (18-45 mph), and a vehicle is
not detected in the rear area of your
vehicle's left and right side lanes, the
function will change to the standby
state.
•
If there is a risk of collision, the
function will change to the standby
state.
•
The images and colors in the
instrument cluster may differ
depending on the cluster type or theme
selected from the infotainment system.
To Next Page
Loading...
