2
Operating instructions
Contents
Preface -----------------3
Associated documents ---------3
Conventions --------------3
Symbol Keys --------------3
Abbreviations --------------3
User responsibility -----------4
Daily ------------------4
Weekly -----------------4
Quarterly ----------------4
Limitation of false alarm ---------4
Control and indicating equipment ----5
Control panel --------------5
Repeat panels -------------5
Description of controls and indications - - 6
Navigation ---------------8
Normal condition ------------9
How to enter 'Customer mode' PIN
for access to Level 2 menus -------9
Weekly tests --------------10
How to enter the Weekly test mode - - - 10
How to exit the Weekly Test mode----11
How to view the active Test log -----11
How to manually raise an alarm of FIRE - 12
Automatic detection of FIRE -------13
Coincidence Fire Detection -------14
Fault condition -------------15
Typical fault messages ---------16
Disablement condition----------17
Typical Disablement Messages -----17
To carry out a display test --------18
How to change time and date ------18
How to view or print the
Historic Events log -----------19
How to view or print active Fire events- - 19
How to view or print active Fault events - 20
How to view or print active
Disablement events -----------20
How to put the system in 'Day mode'
or 'Night Mode' -------------21
How to view, enable/disable
or test mode a Zone-----------21
How to view or enable/disable
an alarm Sector ------------22
How to view the Loop map
and Device details -----------22
How to view channel details
of interface devices -----------23
How to enable/disable master alarms,
fire relay and evacuate input ------23
How to view the Loop status-------24
How to view panel 'Firmware' version - - 24
How to view 'Site data' version -----25
The 'Loop Repair' option --------25
General Maintenance ----------26
Replacing the glass on a
Manual Call Point ------------26
Resetting the resettable element
on a Manual Call Point ---------26
Battery replacement-----------26