28142 Rev 15 ADJUSTMENT
Gentherm Global Power Technologies Page 40
8 ADJUSTMENT
This section describes how to adjust the Model 5220 Thermoelectric generator.
NOTE:
Typical fuel pressure settings are 130 - 144 kPa (18.5 - 21 PSI) for natural gas
and 125 - 140 kPa (18 - 20 PSI) for propane.
NOTE:
Good record keeping is necessary for long term follow-
Performance Log, located at the end of this manual, for recording details each
time adjustments are made, or service is carried out.
Figure 22 – Change in Fuel Gauge Pressure vs Elevation Above Sea Level
TEG power output is determined by the flow of air and fuel into the burner. Follow these
procedures – in the order given – to adjust the TEG’s power output.
To Next Page
Loading...