Firmware Update
Copy firmware update.gsc file to the SD card root directory.
UAV will automaticly detect firmware file and will start the update process, when the
power is turned on.
UAV and Flight Battery firmwares will be updated. UAV LED indicator will be flashing
orange during the updating process.
The duration of update process can be up to 5 minutes.
After the successful update UAV will be rebooted, automatically will check all systems
and will switch in ready to flight mode.
When the update is completed, firmware update file will be automatically renamed to
success_update.gsc.
In order to update the firmware of more than one battery, you should turn UAV power off,
remove the updated battery, replace battery with an older firmware version and repeat
the upgrade process by renaming the file to update.gsc.
Also you can copy the file and use it for update another Geoscan Gemini UAVs.
Contact our technical support https:// www.geoscan.aero/ support for the latest firmware
updates.
25
To Next Page
Loading...
