Connection Settings
Radiomodem Connecting
The radio modem is used to load a flight task into the autopilot
memory, set up and semi-automatic control the UAV flight up
to 5 km using the Geoscan Planner software. This section
describes how to set up wireless connection between the UAV
and laptop.
1. Connect the radiomodem to laptop’s USB port.
2. Install MdmDisp and NetTopology software.
3. Turn the UAV power on.
4. Launch the MdmDisp utility.
The antenna icon and the number of connected boards will be displayed
in a right corner of the laptop screen.
4.1 At the first time you need to configure connection with UAV.
1) Run the NetTopology utility.
2) Press Search button.
The program will show the list of detected devices. The search will continue until the
Search new devices button will be pressed again.
3) Select UAV №501xxxx and press Add device button.
The utility saves the list of added devices automatically.
Before the next flights just run MdmDisp and check the successful connection.
37
To Next Page
Loading...
