Launch
Use this section to check pre-flight actions.
1) Charge the flight battery (see Charge mode section for details).
2) Create a flight task in Geoscan Planner
(see Geoscan Planner Software section for details).
Save the project to quickly load a flight task before the flight.
3) Attach propellers to motor shafts and install the flight battery in UAV battery slot.
(see Assembly section for details).
4) Format SD card in FAT32 file system and install it to SD card slot.
5) Remove the lens cap from the camera.
6) Install UAV on the launch pad and make sure that the propellers are rotating
without any problems.
7) Press the battery control button once, again, and hold until all LEDs are lights first
time ( 2 seconds), to turn UAV on and wait for system initialization.
8) Open a project in Geoscan Planner. Connect the UAV. Launch the Preparing
wizard. Make sure that pre-launch check is successful.
9) Press Start button in Geoscan Planner.
UAV will take off and start the flight task.
After completion of the flight task, UAV will automatically land to the start point, if another
landing point is specified (see Landing point section for details).
The Cancel tool also sends the UAV to land at the starting point.
49
To Next Page
Loading...
