Target Bullet Camera
11 11
11.3 Installation
You can install the camera to the ceiling or wall. Follow the steps below.
IMPORTANT: To avoid foggy live view, please replace Silica Gel Tape
prior to installation and use waterproof tape to seal the RJ45 connector.
1. Slide the sun-shield cover onto the top of the camera.
Note: The GeoVision logo on the sun-shield cover should be closer to
the front of the camera.
2. Line up the screw hole on the camera with the opening on the
sun-shield cover.
109
To Next Page
Loading...
Need help?
General
