Restoring to Default Settings
24
4.
Rel
eas
e
the default button. When the process of loading default
settings is completed, the camera reboots automatically.
5. Replace the Silica Gel Tape inside the camera cover and fasten the
camera’s cover immediately.
Vandal Proof IP Dome
1. Keep the power and network cables (or PoE) connected to the
camera.
2. Use a pin to press and hold the default button on the inner housing.
Status LED
Default button
DefaultStatus LED
3. Release the default button when the status LED blinks. This shall
take about 8 seconds.
4. When the status LED fades, the process of loading default settings is
completed and the camera reboots automatically.
241
To Next Page
Loading...
Need help?
General
