Transport, installation and commissioning
5.2.3 Connecting the water hose
A defect, material fatigue or incorrect installation in the water-
bearing system may result in water damage.
Always have installation and repair work carried out by
trained specialist personnel. The manufacturer is not
liable for damage caused by unauthorised persons.
The manufacturer accepts no liability for any water
damage which can be prevented by the use of
appropriate precautionary measures (e.g. Aquastop),
wear and tear or material fatigue.
Observe the following instructions:
The machine may only be installed at a cold water
connection suitable for drinking water.
Ensure that the water used for the vending machine meets
the requirements for food consumption.
The cold water inlet to the machine must be equipped with
a stopcock.
Before the machine is connected to the water pipe, it must
be flushed sufficiently.
The rinsing process should take at least between 20 and 30
seconds. The procedure may have to be repeated.
The connection water pipe must not be kinked.
To avoid flooding, make sure that the connecting cables are
firmly connected.
To Next Page
Loading...