Gerhardt S Series - Connect Water Filter (Optional)

Transport, installation and commissioning
33
Method
1. Connect the water tap and the water connection of the
machine with a suitable water connection hose.
2. ATTENTION! The water connection must be carried out
correctly and, if necessary, by an installation technician.
The manufacturer accepts no liability for damage caused by
a faulty water connection.
3. Check for correct fit.
4. Open the water pipe.
5. Check that the connection is absolutely tight and that no
water escapes at any point.
5.2.4 Connect water filter (optional)
NOTE
 Above a water hardness of 6° dH (°KH), a water filter
must be connected upstream of the boiler.
 If available, observe the bypass setting on the filter
head.
 Follow the operating instructions of the water filter.
Method
1. Connect the water tap to the filter inlet of the filter head.
2. Mount the filter cartridge on the filter head.
3. Open the water line.
4. Keep the rinse button on the filter head pressed until
approx. 10 litres of water have passed through the filter.
5. Connect the filter outlet to the water line to the inlet valve.