Transport, installation and commissioning
5.3.2 Rinsing the boiler
To prevent water and cold damage during transport or
storage, the water circuit was emptied in the factory as
a precautionary measure.
Method
1. Unlock and open the automatic door with the key.
If the boiler needs to be flushed (filled), the machine
automatically indicates this on the touchscreen.
2. Follow the instructions on the touchscreen.
5.3.3 Filling the powder container
Only products suitable for automatic machines may be
used.
Fill products only loosely.
The products must not be compacted.
Never fill these containers with liquids.
Method
1. Remove cover.
2. If necessary, shake the powder remaining in the powder
container.
3. Fill the powder container with the same product.
4. To avoid lumps, loosen the product to be filled.
5. To close the lid, snap the nose of the lid into the recess in
the powder container.
To Next Page
Loading...