Gerhardt S Series - Cleaning the Output

Cleaning and care
52
7.5 Cleaning the output
Method
1. Unlock and open the automatic door with the key.
2. Remove the drip cup and replace it with a fresh cup.
3. Remove the drip tray.
4. Unlock and remove the drip grid.
5. Unlock and remove the bracket.
6. Remove the cup table.
7. Rinse and clean the drip tray, drip grid and cup table under
running hot water.
8. Clean output housing.
Method
1. Insert the cup table in the folded-up position from above.
2. Insert and lock the bracket.
3. Push the drip grid into the guide.
4. Insert empty drip cup.
5. Close the automatic door and lock it with the key.
Removing components
Installing components