Gerhardt S Series - Connecting the Power Plug; Commissioning; Switching on the Coffee Machine

Transport, installation and commissioning
34
5.2.5 Connecting the power plug
The following instructions must be observed:
 Make sure that the mains voltage corresponds to the
voltage indicated on the nameplate of the machine. The
type plate is located at the top left on the inside of the
machine.
 Only connect the machine to a properly installed power
outlet.
 The socket must be protected by at least a 16 A fuse.
 Do not use extension cords and multiple sockets.
 The earthed plug must be easily accessible after setting up
the machine.
5.3 Commissioning
NOTE
 Installation and commissioning of the machine may only
be carried out by trained specialist personnel.
5.3.1 Switching on the coffee machine
NOTE
 Check the safe state of the machine before
commissioning
 The water inlet must be tight and open.
 The device must be properly connected to the power
supply.
 After switching on, it takes a moment until operating
instructions are displayed on the touchscreen.
Method
1. Switch on the machine at the main switch. The main switch
is located at the top left on the inside of the machine.
2. Follow the instructions on the touchscreen.