Gerhardt S Series - Setting the Grinding Degree

Transport, installation and commissioning
38
Method
1. Unpack the lid according to the hygiene concept.
2. Fill the lid into the lid shaft with the top of the lid facing
upwards.
3. Fill the lid regularly and horizontally into the lid shaft.
4. Turn the drum until it reaches the next lid shaft.
5. Repeat the procedure.
Method
1. Lift up the lid dispenser until the lid dispenser is locked by
the magnetic lock.
2. To check the function, press the test button at the bottom
right of the lid dispenser.
3. Close the automatic door and lock it with the key.
5.3.7 Setting the grinding degree
The grinding degree of the coffee beans influences the taste of
the coffee. The grinding degree was preset before delivery and
does not necessarily have to be readjusted before putting into
use. However, the grinder reacts very differently to different types
of coffee during grinding. It may therefore be necessary to adjust
the grinding degree. After filling in another type of coffee, the
grinding degree may have to be adjusted again.
Method
1. Unlock and open the automatic door with the key.
2. To move the brewer into service position: Select Service
menu > Functions-Tests > Move brewer.
3. Fit the red handwheel supplied on the top right of the
grinder onto the hexagon bolt.
4. To adjust the grinding degree, gradually turn the infinitely
variable grinding degree adjustment on the grinding
mechanism.
Direction of rotation
Powder
Brewing time
Clockwise
Finer
Longer
Anticlockwise
Coarser
Shorter
5. ATTENTION! Danger of material damage! The attached
handwheel must be removed again after adjustment. The
Fill lid dispenser
Locking the lid dispenser