Getac V110 - Using the Network Features

2-14
Operating Your Computer
Using the Network Features
Using the LAN
To connect the network cable to the LAN module, connect one end of the
LAN cable to the RJ-45 connector on the computer and the other end to the
network hub.
Using the Wireless LAN
The WLAN module of your computer supports IEEE 802.11a/b/g/n/ac.
Turning On/Off the WLAN Radio
To turn on the WLAN radio:
1. Make sure that the Airplane mode is switched off. You can control the
Airplane mode using one of the below methods.
• Press Fn+F1.
• Use the Airplane Mode button in the OSD Control Panel.
• For Windows 8: Open the Charms Bar, tap Settings  Change PC
Settings  Wireless. Slide the Airplane mode switch to the Off
position.
2. If you have previously turned off the WLAN radio, use one of the below
methods to turn it on.
• For Windows 8: Open the Charms Bar of Windows. Tap Settings 
Change PC Settings  Wireless. Slide the Wi-Fi switch to the On
position.