5-12
Using BIOS Setup and System Recovery
Password on Boot allows you to enable or disable the entering of password
for booting up your system. Once the password is successfully set and this
item is enabled, it is required for booting up the system.
Set HDD 0 Password sets the password for locking the Primary Master hard
disk drive. After setting a password, the hard disk drive can only be
unlocked by the password no matter where it is installed.
HDD 0 Password Is shows whether you have set the hard disk password or
not.
TPM Setup Menu sets various TPM parameters. Press Enter to access the
submenu as shown below.
TPM Support enables or disables TPM (Trusted Platform Module)
support. TPM (Trusted Platform Module) is a component on your
computer’s mainboard that is specifically designed to enhance platform
security by providing a protected space for key operations and other
security critical tasks.
Current TPM State shows the current TPM state.
Change TPM State allows you to select between
No Change
,
Clear
,
Deactivate & Disable
, and
Enable & Activate
.
F1 Help ↑↓ Select Item +/- Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select Sub-Menu F10 Save and Exit
To Next Page
Loading...
Need help?
General
