Getac V200 User Manual

Using BIOS Setup and System Recovery 5-11
Security Menu
The Security menu contains the security settings, which safeguard your
system against unauthorized use.
Information
Main
Advanced
Security
Boot
Exit
Supervisor Password Is:
User Password Is:
Set Supervisor Password:
Set User Password
Password on Boot:
Set HDD 0 Password:
HDD 0 Password:

TPM Setup Menu
Intel Trusted Execution Technology
Cleared
Cleared
[Enter]
[Enter]
[Disabled]
[Enter]
Cleared
[Disabled]
Item Specific Help
Set or clear the
Supervisor account’s
password.
F1 Help ↑↓ Select Item +/- Change Values F9 Setup Defaults
Esc Exit ←→ Select Menu Enter Select  Sub-Menu F10 Save and Exit
NOTE:
 You can set the user password only when the supervisor password has
been set.
 If both the administrator and user passwords are set, you can enter any
of them for starting up the system and/or entering BIOS Setup.
However, the user password only allows you to view/change the settings
of certain items.
 A password setting is applied right after it is confirmed. To cancel a
password, leave the password empty by pressing the Enter key.
Supervisor/User Password Is shows whether you have set the
supervisor/user password or not for the system.
Set Supervisor/User Password sets the supervisor/user password. When
typing the password, first make sure that Num Lock is off, and then type the
password in the entry fields and press Enter. Confirm your password by
typing it again and pressing Enter. You can set the supervisor/user password
to be required for starting up the system and/or entering BIOS Setup.
Enter

Getac V200 Specifications

General

Brand	Getac
Model	V200
Category	Laptop
Language	English