48 | Appendix 2: Microsoft Exchange 2007/2010 Connector GFI FaxMaker
set-ForeignConnector -identity "GFIFaxmaker" -DropDirectory "<GFI
FaxMaker Folder>\SinkDrop"
Replace <GFI FaxMaker Folder> with the GFI FaxMaker installation folder path. For
example, C:\Program Files (x86)\GFI\FaxMaker.
GFI FaxMaker installed on a separate machine
From the Microsoft Exchange Management Shell, run the following commands:
1. Create a Receive Connector:
new-receiveconnector -name "GFIFaxMaker" -Bindings "0.0.0.0:25" -
RemoteIPRanges "10.10.10.10" -AuthMechanism "ExternalAuthoritative"
-PermissionGroups "ExchangeServers" -fqdn "faxmaker.com"
Replace 10.10.10.10 with the IP address of the GFI FaxMaker machine.
2. Create a Send Connector:
new-SendConnector -name “GFIFaxMaker” -DnsRoutingEnabled:$false -
Smarthosts:10.10.10.10 -AddressSpaces
“FAX:*”,”SMS:*”,”SMTP:faxmaker.com”,”SMTP:smsmaker.com”
Replace 10.10.10.10 with the IP address of the GFI FaxMaker machine.
9.3 Removing the connectors automatically
GFI FaxMaker installed on Microsoft Exchange Server
If the connectors were created automatically during installation of GFI FaxMaker, the
connectors are automatically removed during uninstall.
No further configuration is required.
NOTE: If the connectors are not named GFIFaxMaker (for example, if connectors
were renamed or were manually created using a different name), remove the
connectors manually. For more information refer to Removing the connectors
manually section in this manual.
GFI FaxMaker installed on a separate machine
If the connectors were created automatically by running the GFI FaxMaker setup on the
Microsoft Exchange server, the connectors are automatically removed by uninstalling GFI
FaxMaker.
No further configuration is required.
NOTE: If the connectors are not named GFIFaxMaker (for example, if connectors
were renamed or were manually created using a different name), remove the
connectors manually. For more information refer to Removing the connectors
manually section in this manual.
9.4 Removing the connectors manually
GFI FaxMaker installed on Microsoft Exchange Server
From the Microsoft Exchange Management Shell, run the following commands:
To Next Page
Loading...
