Gilson Minipuls 3 - Page 65

Command K
Type Buered
Mode Remote
Function Input remote keystrokes. Mimic key actions.
Syntax K codes
Parameters
String of characters as follows:
“<” = backwards (CCW)
“>” = forwards (CW)
“+” = faster
“-” = slower
“H” = stop
“&” = rabbit
Comments All other characters are ignored. A buered “K” command must be the last in a command string.
Note: To make this command work properly, the MINIPULS 3 should not be disconnected from the system master until the
buer is empty. To ensure that this is true the master should send another command (such as an empty string) immediately
after any string containing a “K” command. Completion of the first string is implied as soon as the second is accepted
59
MINIPULS® 3 PERISTALTIC PUMP | USER'S GUIDE
ELECTRICAL CONTACT CONTROL