GlideScope Titanium - Setting up; Procedure 1. Perform Initial Inspection

14
SETTING UP
Before you can use the GlideScope Titanium system for the first time, you must inspect the components, set up
the system, and perform a functional test as recommended by Verathon
®
. Complete the following procedures:
1. Perform Initial Inspection—Inspect the system for any obvious physical damage that may have occurred
during shipment.
2. Mount the System (Optional)—Set up the GlideScope Video Monitor on a mobile stand or IV pole.
3. Charge the Monitor Battery—Note that you can use the system while the battery is charging.
Note: The monitor will operate without charging the battery by using the GlideScope Video Monitor 12V DC
power adapter that shipped with the unit.
4. Attach the Video Cable & Blade—Connect the video cable or GlideScope Smart Cable to the monitor, and
then connect the video laryngoscope to the video cable or Smart Cable.
5. Connect to an External Monitor (Optional)—Connect the monitor to an external display source, such as a
larger monitor screen, by using the HDMI-to-DVI cable.
6. Configure User Settings—Enter data customized to your clinic, and configure settings such as the date
and time.
7. Perform a Functional Check—Before you use the device for the first time, perform a functional check to
ensure that the system is working properly.
PROCEDURE 1. PERFORM INITIAL INSPECTION
When you receive the GlideScope Titanium system, Verathon recommends that an operator familiar with
the instrument perform a full visual inspection of the system for any obvious physical damage that may have
occurred during shipment.
Note: Due to the hand-polishing method used to create the titanium exterior of the reusable blades, slight
variations or irregularities may occur in the finish. These variations do not affect the cleaning process or
system efficacy.
1. Verify that you have received the appropriate components for your system by referring to the packing list
included with the system.
2. Inspect the components for damage.
3. If any of the components are missing or damaged, notify the carrier and Verathon Customer Care or your
local representative:
800.331.2313 (Canada and US)
+1.425.867.1348 (International)
+31 (0) 20 210 30 91 (Europe)
For additional contact information, see Contact Information.