GlideScope Titanium - Page 42

36
CHEMICAL LEVEL COMPONENT CYCLES* CONDITIONS
STERIS
®
eSSENTIALS
Concentrates
™
Cleaner Blade 750
Water temperature: 30–40°C (86–104°F)
Exposure: Prepare solution at 0.125–1ounce/gallon (1–8mL/L).
Soak component for 5 minutes. Before removing from solution,
brush all surfaces and pay special attention to hard-to-reach
areas. Use a syringe to flush the connector.
Rinse: Rinse for 3 minutes under running water. Flush the
connector with running water and a syringe.
Pro-Line
Solutions
EcoZyme
®
Cleaner
Blade 3000
Water temperature: 19–29°C (66–84°F)
Exposure: Prepare solution at 1ounce/gallon (7.81 mL/L) in
30–40°C (86–104°F) water. Soak component for 5 minutes.
Before removing from solution, brush all surfaces and pay special
attention to hard-to-reach areas. Using a syringe, flush the
connectors.
Rinse: Rinse for 5 minutes under running water. Using a syringe,
flush the connectors.
Video Cable 3000
Smart Cable 1500
Metrex
®
CaviWipes™
Cleaner
Video Cable 1500
Water temperature: N/A
Exposure: Use towelette(s) to remove all visible contamination
from the component. Using fresh towelette(s), wet all surfaces
and allow to remain wet for 3 minutes.
Rinse: N/A. Allow the component to thoroughly air dry.
Smart Cable 1500
Wip’Anios
Premium
Cleaner
Video Cable 1500
Water temperature: N/A
Exposure: Use towelette(s) to remove all visible contamination
from the component. Using fresh towelette(s), wet all surfaces
and allow to remain wet for 5 minutes.
Rinse: N/A. Allow the component to thoroughly air dry.
Smart Cable 1500
Clinell
®
Universal
Sanitizing
Wipes
Cleaner
Video Cable 1500
Water temperature: N/A
Exposure: Use towelette(s) to remove all visible contamination
from the component. Using fresh towelette(s), wet all surfaces
and allow to remain wet for 5 minutes.
Rinse: N/A. Allow the component to thoroughly air dry.
Smart Cable 1500
Sani Cloth
®
Active Wipes
Cleaner
Video Cable 1500
Water temperature: N/A
Exposure: Use towelette(s) to remove all visible contamination
from the component. Using fresh towelette(s), wet all surfaces
and allow to remain wet for 5 minutes.
Rinse: N/A. Allow the component to thoroughly air dry.
Smart Cable 1500
* Value indicates number of compatibility cycles tested on the component. Exceeding the recommended number of cycles may affect the potential life of
the product.
† Do not use this solution to clean a GlideScope Smart Cable.