Glow-worm ENERGY - Installing the white variable terminal kit (VTK); Installing the black variable terminal kit (VTK)

5 Set-up
20 Installation manual 0020237648_03
5.1.10.3 Scope of delivery
1 2
3
4
567
1 87° elbow (2 x)
2 Pipe clamps (3 x)
3 Extension (1 m) without
sleeve
4 Extension (1 m) with
sleeve
5 End pipe
6 Opening piece
7 Wall collar (only in-
cluded in the variable
terminal kit, black)
– Variable terminal kit, black, article number 0020219531
– Variable terminal kit, white, article number 0020219532
(no wall collar)
5.1.10.4 Installing the black variable terminal kit
(VTK)
▶ Proceed as described in section "Installing the black ter-
minal (change of colour)" (→ Page 15).
5.1.10.5 Installing the white variable terminal kit
(VTK)
A
B
1. Release the catch between the opening piece and the
end pipe.
2. Pull the end pipe from the opening piece.
0°
3. Slide the first 87° elbow onto the opening piece until the
87° elbow audibly clicks into place.
5.1.10.6 Installing extensions
1. Install the flue system from the 87° elbow to the flue
outlet.
– Begin with the extension with the sleeve. To be able
to install the second 87° elbow with the end pipe,
you must install the extension without a sleeve last.
– Allow expansion space of 1 cm in each sleeve.
– Ensure that all pipe joints are absolutely leak-tight.