GME CP30 - Page 73

69
CP30 INSTRUCTION MANUAL
Naming a Receive-only Channel
While in the CHAN sub-menu:
1. Rotate the Channel Selector knob or press the keys to cycle
through the sub-menu until NAME is displayed.
2. Press
MENU
F
. The current name for the selected channel is displayed.
If the channel is a new receive-only channel, -- -- -- -- -- -- is displayed
to indicate a name has not been set, otherwise the last entered name
is displayed.
3. Hold the
MENU
F
key to edit the name. The cursor will ash in the left-
hand character position.
4. Press the or keys or rotate the Channel Selector knob to
select the desired character.
Available characters are:
PUNCTUATION NUMBERS LETTERS
– + * , _ 1 2 3 4 5 6 7 8 9 0 A B C D E F G H I J K L M N O P Q R S T U V W X Y Z
5. When the desired character is displayed, press
MENU
F
to select. The
ashing cursor will move to the next character position.
6. Repeat the process to enter up to 6 characters for the desired name.
7. When the desired name is displayed, hold
MENU
F
to save. The name will
ash as it is saved. Press
MENU
F
to exit the menu.