GME CP30 - Page 72

CP30 INSTRUCTION MANUAL
68
• If you have only just created a new channel, the desired channel
number should already be displayed.
• If not, you will need to exit the menu (select EXIT and hold the
MENU
F
key). You can then select the desired channel before re-entering the
menu and navigating back to the CHAN sub-menu.
NOTE: You cannot remove (delete) a CB channel nor can you edit any of the
properties of a CB channel although you can view them.
While in the CHAN Sub-menu:
1. Rotate the Channel Selector knob or press the keys to cycle
through the sub-menu until RXFRQ is displayed.
2. Press
MENU
F
. The current receive frequency for the selected channel is
displayed.
• If the channel is a new receive-only channel, 403.000 is
displayed otherwise the last entered frequency is displayed.
NOTE: 403.000 MHz is the lowest frequency you can program
into the CP30.
3. Hold the
MENU
F
key to edit the frequency. The cursor will ash in the
10 MHz digit position.
4. Press the keys or rotate the Channel Selector knob to adjust
the frequency in 10 MHz steps between 403 and 520 MHz.
5. When the desired value is displayed, press
MENU
F
to select. The ashing
cursor will move to the 1 MHz digit position.
6. Repeat the process to adjust the frequency in the 1 MHz, 100 kHz and
10 kHz positions. Note that when adjusting the 10 kHz position the
frequency will change in 12.5 kHz steps.
7. When the desired frequency is displayed, hold
MENU
F
to save. The entire
frequency will ash as it is saved. Press
MENU
F
to exit the menu.
Viewing the Frequency of a CB or Private Channel
While in the CHAN sub-menu:
1. Rotate the Channel Selector knob or press the keys to cycle
through the sub-menu until RXFRQ is displayed.
2. Press
MENU
F
. The receive frequency for the selected CB channel is
displayed.
3. Press
MENU
F
to exit the menu.