GME CP30 - Page 71

67
CP30 INSTRUCTION MANUAL
• On private channels - displays ON or OFF to indicate whether Busy
Lockout is active on the channel.
• On CB channels - displays GLOBAL to indicate the Busy Lockout
setting in the main menu applies to all CB channels.
SelCall:
• On receive-only channels - displays OFF since SelCall is not supported
on receive-only channels.
• On CB and private channels - displays ON or OFF to indicate whether
the channel supports SelCall.
NOTE: SelCall is not supported on channels 61, 62 and 63 or on emergency
channels 5/35.
Adding a Receive-only Channel
While in the CHAN sub-menu:
1. Rotate the Channel Selector knob or press the keys to cycle
through the sub-menu until ADD is displayed.
2. Press
MENU
F
to select. The CP30 will respond with ADD? and the next
available receive-only channel number will be ashing.
3. To cancel and exit without adding a receive-only channel:
i. Briey press
MENU
F
. The selected channel number will be restored
and you will exit the menu.
4. To continue adding a receive-only channel:
i. Rotate the Channel Selector knob or press the keys
to select the desired receive-only channel number. Only empty
channel numbers in the range of 81 to 199 will be displayed.
ii. When the desired channel number is ashing, hold
MENU
F
to
accept. The new channel will been created and you will be
returned to the CHAN sub-menu.
NOTE: New channels are automatically loaded with a frequency of 403.000 MHz.
Once created, you will need to edit the frequency to suit your requirements.
Editing the Frequency of a Receive-only Channel
IMPORTANT: Before editing or reviewing any channel properties, check that the
desired channel number is displayed.