GME CP30 - Page 80

CP30 INSTRUCTION MANUAL
76
Beep Cycle
Press the programmed Beep key to cycle ON, OFF or ALT.
• ON: The radio will beep whenever a key is pressed or when an alert is
required.
• OFF: All Beeps are inhibited.
• ALT: The radio will only beep when an alert is required. Key beeps are
inhibited.
Beep Menu
1. Press the programmed Beep Menu key to access the Beep menu.
2. Rotate the Channel Selector knob or press the keys to select ON,
OFF or ALT.
• ON: The radio will beep whenever a key is pressed or when an
alert is required.
• OFF: All Beeps are inhibited
• ALT: The radio will only beep when an alert is required. Key
beeps are inhibited.
3. Press the
MENU
F
key to exit or wait a few seconds for the menu to time-out.
CB PTT ANI Toggle
Press the programmed CB PTT ANI Toggle key to toggle PTT triggered SelCall
ANI transmission on CB channels ON or OFF. The setting Enable PTT ANI on CB
Channels must be enabled in the dealer programmer.
Channel Announce Toggle
Press the programmed Channel Announce Toggle key to toggle the Channel
Announce setting ON or OFF.
Channel Announce Menu
1. Press the programmed Channel Announce Menu key to access the
Channel Announce menu.
2. Rotate the Channel Selector knob or press the keys to switch
the Channel Announce setting ON or OFF.
3. Press the
MENU
F
key to exit or wait a few seconds for the menu to time-out.