EasyManuals Logo

Graco GM 5000 User Manual

Graco GM 5000
47 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
307-847 17
PROBLEM
CAUSE SOLUTION
Displacement pump output
low on upstroke
Pump inlet screen clogged
Clean.
Piston ball check not seating
Service piston ball check. See page 31.
Piston packings worn or damaged
Replace packings. See page 31.
Sleeve gasket in displacement
pump worn or damaged
Replace. See page 31.
Displacement pump output
low on downstroke or both
strokes
Pump inlet screen clogged
Clean.
Piston packings worn or damaged
Replace packings. See page 31.
Intake valve ball check not seating
properly
Clean and service. See page 31.
Engine RPM too low
Increase throttle setting. See
Startup,
Step 1
1, page 12.
Clutch worn or damaged
Replace. See page 22.
Paint leaks into wet–cup
Loose wet–cup
T
ighten just enough to stop leakage.
Throat packings worn or damaged
Replace packings. See page 31.
Displacement rod worn or damaged
Replace rod. See page 31.
Low fluid delivery
Pump inlet screen clogged.
Clean.
Pressure setting too low
Increase pressure. See
Startup,
Step 1
1, page 12.
Engine RPM too low
Increase throttle setting. See
Startup,
Step 1
1, page 12.
Dirty outlet filter
, tip filter or tip
Clean.
Large pressure drop in hose
Use larger diameter hose.
Spitting from gun Air in fluid pump or hose Check for loose connections at pump in
-
take and tighten. Then prime the pump.
See page 12.
T
ip partially clogged
Clear.
Fluid supply is low or empty Refill and prime the pump. See
Startup,
page 12. Check fluid supply often to pre
-
vent running the pump dry
.
Pump is dif
ficult to prime
Air leak
Check all hose connections and tighten as
needed.
Reduce RPM and cycle pump as slowly
as possible during priming.
Intake valve is leaking
Shut of
f pump and relieve pressure. Dis
-
assemble and clean intake valve. Be sure
ball seat is not nicked or worn and that the
ball seats well. Reassemble.
W
orn packings
Repack the pump. See page 31.
Fluid is too thick
Thin fluid according to supplier
’s
recommendations.

Other manuals for Graco GM 5000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Graco GM 5000 and is the answer not in the manual?

Graco GM 5000 Specifications

General IconGeneral
BrandGraco
ModelGM 5000
CategoryPaint Sprayer
LanguageEnglish

Related product manuals