Graco GM 5000 - Technical Data; Engine Specs, Dimensions, and Contact

 
Technical Data
Engine 5 Horsepower , Honda . . . . . . . . . . . . . . . . . . . . . .
Maximum W orking Pressure 3000 psi (210 bar) . . . . . .
Noise – Sound Power 105 dBa . . . . . . . . . . . . . . . . . . . . .
measured at 3.1 ft (1 m)
Cycles/Gallon (liter) 104 (27.5). . . . . . . . . . . . . . . . . . . . .
Maximum Delivery 1.25 GPM (4.7 liter/min) . . . . . . . . . .
Fuel T ank Capacity 0.95 gallons (3.6 liter) . . . . . . . . . . .
Maximum T ip Size 1 gun with 0.035 tip . . . . . . . . . . . . . .
2 guns with 0.025 tip
3 guns with 0.019 tip
Inlet Paint Strainer 16 mesh (1 190 micron) . . . . . . . . . . .
Stainless Steel screen, reusable
Outlet Paint Filter 60 mesh (250 micron) . . . . . . . . . . . . .
Stainless Steel screen, reusable
Pump inlet Size 3/4 npt (m). . . . . . . . . . . . . . . . . . . . . . . .
Fluid Outlet Size 1/4 npsm from fluid filter . . . . . . . . . . .
Wetted Parts
Displacement Pump Stainless Steel, Carbon Steel, .
Polyurethane, UHMW polyethylene,
Delrin , Leather
Filter Aluminum, Carbon Steel, Stainless Steel . . . . .
NOTE: Delrin is a trademark of the DuPont Company .
Dimensions
Model 220–886
Upright cart without hose or gun
W
eight (dry , without packaging) 135 lb (61 Kg) . . . . . . .
Height 31.6 in. (803 mm). . . . . . . . . . . . . . . . . . . . . . . . . .
Length 30.5 in. (775 mm). . . . . . . . . . . . . . . . . . . . . . . . . .
Width 22.5 in. (572 mm). . . . . . . . . . . . . . . . . . . . . . . . . . .
Model 222–488
Lo-Boy cart without hose or gun
W
eight (dry , without packaging) 130 lb (58.5 Kg) . . . . .
Height 26.5 in. (673 mm). . . . . . . . . . . . . . . . . . . . . . . . . .
Length 36 in. (914 mm). . . . . . . . . . . . . . . . . . . . . . . . . . .
Width 19 in. (483 mm). . . . . . . . . . . . . . . . . . . . . . . . . . . .
Graco Phone
Number
TO PLACE AN ORDER , contact your Graco distrib -
utor
, or call this number to identify the distributor
closest to you: 1–800–367–4023 T oll Free
Manual Change
Summary
Added a procedure to set the clearance between rotor
and
the field, on page 27.