Grandstream Networks GSC35 Series User Manual

GSC35XX Series User Manual
Version 1.0.0.15
P a g e | 45
Refer-To Use Target
Contact
Sets the device to use the target’s Contact header tag to the Refer-To
header in the SIP REFER message during an attended transfer.
The default setting is “No”.
Dial Plan
Dial Plan Prefix
This parameter can be configured to define the prefix added to each dialed
number.
Disable DialPlan
Enables/disables the Dial plan mechanism for different cases. If the specific
case is checked, the Dial plan mechanism will be disabled.
• Dial Page: It controls the pattern of dialing numbers from the call
page.
• Contact: It controls the pattern of dialing numbers from local, LDAP
and Broadsoft contacts.
• Incoming Call History: It controls the pattern of dialing numbers
from inbound call logs.
• Outgoing Call History: It controls the pattern of dialing numbers
from outbound call logs.
DialPlan
Configures the dial plan to establish the expected number and pattern of
digits for a telephone number. This parameter configures the allowed dial-
plan for the device.
Dial Plan Rules:
1. Accepted Digits: 1,2,3,4,5,6,7,8,9,0 , *, #, A,a,B,b,C,c,D,d,+
2. Grammar: x – any digit from 0-9;
a) xx+ or xx. – at least 2-digit numbers
b) xx – only 2-digit numbers
c) ^ - exclude
d) [3-5] – any digit of 3, 4, or 5
e) [147] – any digit of 1, 4, or 7
f) <2=011> - replace digit 2 with 011 when dialing
g) | - the OR operand
h) \+ - add + to the dialing number
• Example 1: {[369]11 | 1617xxxxxxx}
Allow 311, 611, and 911 or any 10-digit numbers with leading digits 1617
• Example 2: {^1900x+ | <=1617>xxxxxxx}

Grandstream Networks GSC35 Series Specifications

General

Brand	Grandstream Networks
Model	GSC35 Series
Category	Intercom System
Language	English