Grandstream Networks GXV3240 Administration Guide

Firmware Version 1.0.3.46
GXV3240 Administration Guide
Page 60 of 117
When configuring this, it should be noted that the "ptime" value for the
SDP will change with different configurations here. This value is related
to the codec used and the actual frames transmitted during the in
payload call. For end users, it is recommended to use the default
setting, as incorrect settings may influence the audio quality. The
default setting is 2.
Jitter Buffer Maximum (ms)
It is used to define the amount of delay to eliminate jitter caused by
transmission congestion. The valid range is from 0 to 1000.The default
settings is 50.
RTCP Destination
It is used to configure a remote server URI where the RTCP messages
sent to during an active call.

Grandstream Networks GXV3240 Specifications

General

Brand	Grandstream Networks
Model	GXV3240
Category	IP Phone
Language	English