GXV3350 Administration Guide
Version 1.0.3.27
Otherwise, the network will fail to connect.
The URL/IP address for the OpenVPN® server.
The network port for the OpenVPN® server.
By default, it is set to 1194.
Determines network protocol (UDP or TCP) used for OpenVPN®.
Default is UDP.
OpenVPN® CA file (ca.crt) required by the OpenVPN® server for
authentication purposes. Press "Upload" to upload the corresponding file
to the device. The file will not be uploaded if it is not in the correct format.
OpenVPN® Client
Certificate
OpenVPN® Client certificate file (*.crt) required by the OpenVPN® server
for authentication purposes. Press "Upload" to upload the corresponding
file to the device. The file will not be uploaded if it is not in the correct
format.
The OpenVPN® Client key (*.key) required by the OpenVPN® server for
authentication purposes. Press "Upload" to upload the corresponding file
to the device. The file will not be uploaded if it is not in the correct format.
The cipher method of OpenVPN®, must be the same cipher method used
by the OpenVPN® server. Available options are: “Blowfish”, “AES-128” or
“AES-256”. Default is “Blowfish”.
OpenVPN® authentication username (optional).
OpenVPN® authentication username (optional).
Network Settings/Advanced Network Settings
Advanced Network Settings
This fields sets the preferred DNS server for the user.
This fields sets the second DNS server for the user.
Enables the LLDP (Link Layer Discovery Protocol) feature on the phone
system. If it is set to “Yes”, the phone system will broadcast LLDP PDU to
advertise its identity and capabilities and receive same from a physical
adjacent layer 2 peer.
The default setting is "Yes".
Configures the interval the phone sends LLLD-MED packet.
The default setting is 30s.
Configures whether to enable CDP to receive and/or transmit information
from/to CDP-enabled devices. The default setting is "Yes".
Defines the Layer 3 packet’s QoS parameter for SIP messages in decimal
pattern. This value is used for IP Precedence, Diff-Serv or MPLS.
The default setting is 26 it is equivalent to the DSCP name constant AF31.