8. Create an inbound route to use the Fax analog trunk. Select the created extension for Fax machine in step
4 as the default destination.
Figure 157: Configure Inbound Rule for Fax
Now the Fax configuration is done. When there is an incoming Fax calling to the PSTN number for the FXO port,
it will send the Fax to the Fax machine.
Sample Configuration for Fax-To-Email
The following instructions describe a sample configuration on how to use Fax-to-Email feature on the UCM6200.
1. Connect PSTN line to the UCM6200 FXO port.
2. Go to UCM6200 Web GUICall FeaturesFax/T.38 page. Create a new Fax extension.
Figure 158: Create Fax Extension
To Next Page
Loading...
Need help?
General
