Firmware Version 1.0.13.14
• Added extension whitelist/blacklist for IVR dialing. [IVR]
• Added ability to include DOD in PPI Header for SIP trunk. [Use DOD in PPI]
• Added advanced IPv6 support including IPv6-to-IPv4 SIP calls, IPv6 router, IPv6 iptables/Static defense.
• Added ability to customize PAI Header. [PAI Header]
• Added blacklist for outbound calls. [Outbound Blacklist]
• Added support to upload/download MOH package from Web GUI. [MUSIC ON HOLD]
• Added support to download custom prompts from Web GUI. [Download All Custom Prompt]
• Added option to configure prompt timeout in Dial By Name. [DIAL BY NAME]
• Added description field in ZeroConfig settings to configure Softkey/Line/MPK for GXP series phones.
[PROVISIONING]
• Improved seamless transfer privilege control. [Seamless transfer privilege control]
• Added RTP Keep-alive support. [RTP Keep-alive]
• Added Email Send Log. [Email Send Log]
• Added support for Mitel simulation/protocol interfaces for PMS module. [PMS]
• Added support for up to 10 failover trunks. [Use Failover Trunk]
Firmware Version 1.0.12.19
• Added support for binding a mobile phone number to extension. [Mobile Phone Number]
• Added support OPUS codec.
• Added support call-barging privilege settings based on extensions. [Monitor privilege control]
• Added support for Seamless Transfer. [Seamless Transfer]
• Added support for Custom Call-Info for Auto Answer. [Custom Call-info for Auto Answer]
• Added support for DND Whitelist. [Do Not Disturb]
• Add the Field Description on Softkey, Line keys and MPK from Zero Config.
• Added support to select interval for numbers on Batch add extension. [Extension Interval]
• Added support for Batch Add CallerID Number. [CallerID Number]
• Added support for Search Extensions Using CallerID Name.
• Added support to Enable/Disable Inbound and Outbound Route. [Disable This Route/Disable This Route]
• Added support for Outbound Route Time Condition. [Time Condition]
• Added support for IPv6. [IPv6 Address]
• Added Support for MTU configurable. [MTU]
• Added support of CRM. [CRM]
• Added support for Custom Privilege in User Management. [Custom Privilege]
• Added Hotline support for FXS Extension. [Hotline]
• Added support for Separate Wakeup Service. [WAKEUP SERVICE]
• Added ability to provision phones from different network subnets using zero config. [Subnet Whitelist]
• One-key-dial is replaced by Speed Dial to support more than one digit. [SPEED DIAL]
• Added Append extension number in the end of DOD. [Direct Outward Dialing (DOD)]
To Next Page
Loading...
Need help?
General
