Grandstream Networks UCM630 Series User Manual

P a g e | 306
UCM630X Series User Manual
Version 1.0.2.25
3. To stop the recording, enter the "Start/Stop Call Recording" feature code (by default it is *3) followed by # or
SEND again. Or the recording will be stopped once the call hangs up.
4. The recording file can be retrieved under Web GUICDR. Click on to show and play the recording or
click on to download the recording file.
Figure 207: Download Recording File from CDR Page
The above recorded call's recording files are also listed under the UCM630X Web GUICDRRecording
Files.
Figure 208: Download Recording File from Recording Files Page
Enable Spy
If “Enable Spy” option is enabled, feature codes for Listen Spy, Whisper Spy and Barge Spy are available for
users to dial from any extension to perform the corresponding actions.
Assume a call is on-going between extension A and extension B, user could dial the feature code from extension
C to listen on their call (*54 by default), whisper to one side (*55 by default), or barge into the call (*56 by default).
Then the user will be asked to enter the number to call, which should be either side of the active call, extension
A or B in this example.
---------------------------------------------------------------------------------------------------------------------------------------------------
Caution:
“Enable Spy” allows any user to listen to any call by feature codes. This may result in the leakage of user privacy.
---------------------------------------------------------------------------------------------------------------------------------------------------

Grandstream Networks UCM630 Series Specifications

General

Brand	Grandstream Networks
Model	UCM630 Series
Category	Network Hardware
Language	English