Cutting mat : Cutting or plotting is performed on this mat.
Grit roller : Feeds the medium backward or forward.
Push rollers : Pushes the medium against the grit rollers.
Pen carriage : Moves the cutter pen to the left and right.
Cutter pen holder : Hold the cutter pen and moves it up and down.
Pen holder : Holds the pen and moves it up and down.
Pen station : Used to mount the pen before it is used.
Media set lever : Raises or lowers the push rollers during loading of a
medium.
Control panel : Used to operate the cutting plotter and set functions.
USB interface connector : Used to connect a USB cable.
Serial (RS-232C) interface connector : Used to connect an RS-232C serial interface cable.
Stock shaft : Used to load roll media.
Stoppers : Used to hold a roll medium in place (left and right, one
each).
To Next Page
Loading...
