GRAPHTEC CE5000-40CRP - 3.3 Description of Special Functions A

CE5000-UM-251-9370 3-5
3. OPERATIONS
3.3 Description of Special Functions A
The cutting plotter is provided with the special functions described below. These functions are specified only
in special situations, and are not normally used.
(1) Turn on the cutting plotter while holding down the key. The menus for setting the special functions are
displayed.
CE5000-40/60/120
" : " ,  " ; "  E N A B L E D
" W "      P E N  D O W N
P R I O R I T Y   M A N U A L
I N I T . B        2 m m
U P  M O D E  D I S A B L E D
M E D I A     E N A B L E D
H O M E      E N A B L E D
B . W . S .   D I S A B L E D
In GP-GL command mode
M O D E L        7 5 5 0
P R I O R I T Y   M A N U A L
I N I T . B        2 m m
U P  M O D E  D I S A B L E D
M E D I A     E N A B L E D
H O M E      E N A B L E D
C I R C L E       A U T O
B . W . S .   D I S A B L E D
In HP-GL command mode
CE5000-120AP
               
               
               
               
               
               
               
               
               
               
               
               
               
               
               
               
               
               
In GP-GL command mod
e In HP-GL command mode
(2) Scroll up or down to select the required menu using the (NEXT) or (PREV.) keys.
(3) Select the setting details using the and keys, and press the (ENTER) key to register the setting. To
cancel, press the (NEXT) or (PREV.) key. The next menu is displayed.
(4) Once all the settings have been made, turn off the cutting plotter.