CE5000-UM-251-9370 7-1
7. ELECTRICAL ADJUSTMENTS
7. ELECTRICAL ADJUSTMENTS
7.1 DIP Switch Settings
Factory presets (Normal Mode)
Set all the bits to OFF.
SW1
1 2 3 4
ON
OFF
NOV-RAM Clear
Set bit 3 to ON.
SW1
1 2 3 4
ON
OFF
7.2 List of Items Requiring Readjustment
If you replaced one of the units listed in the table below or altered their sensor positions, be sure to readjust
the corresponding items.
Unit name
Item
Main board
Power
supply
Pen block
Pinch roller
sensor
X,Y motor Drive roller
X,Y Motor
drive belt
Auto
registration
mark
sensor
(Except
CE3000-
120AP)
NOV-RAM clear M
Pen force adjustment M M N
Distance adjustment M M M
Auto registration mark sensor
adjustment
N N N M
Gain adjustment M M
Menu setting N
Firmware update M
Belt tension adjustment M M M
No mark: Unnecessary M: Must always be adjusted N: To be adjusted as necessary
Note: The main board must have the latest version of firmware unless otherwise specified.
To Next Page
Loading...
