CE5000-UM-251-9370 1-1
1. INTRODUCTION
1. INTRODUCTION
CAUTION
DOUBLE POLE/NEUTRAL FUSING
1.1 Main Specifications
CE5000-40CRP/60/120
Item CE5000-40CRP CE5000-60 CE5000-120
CPU 32-bit CPU
Configuration Grit rolling
Drive system Digital servo
Maximum cutting area 375 mm x 50 m 603 mm x 50 m 1213 mm x 50 m
Range of guaranteed precision
356 mm x 5 m
*1
584 mm x 5 m
*1
1194 mm x 5 m
*1
Compatible media widths Minimum: 50 mm
Maximum: 482 mm
(19 inches)
Minimum: 50 mm
Maximum: 712 mm
(28 inches)
Minimum: 85 mm
Maximum: 1346 mm
(52 inches)
Maximum media thickness 0.25 mm
Maximum cutting speed 60 cm/s (in all directions) 100 cm/s (45° direction)
Specifiable cutting speeds
1–10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 cm/s 1–10, 15, 20, 25, 30, 35, 40, 45,
50, 55, 60, * cm/s
Cutting force 0.2 to 2.3 N
(20 gf to 300 gf) (31 levels)
0.2 to 4.4 N
(20 gf to 450 gf) (38 levels)
Minimum character size
Approximately 5 mm for alphanumeric characters (varies depending on the medium, font, etc.)
Mechanical resolution 0.005 mm
Programmable resolution
GP-GL: 0.1/0.05/0.025/0.01 mm; HP-GL
TM *2
: 0.025 mm
Repeatability precision
0.1 mm or less per 2 m
*1
No. of pens mountable 1 pen
Compatible cutter type Supersteel cutter blades
Compatible pen type Water-based fiber-tip pens
Compatible cutting film Marking film (PVC, fluorescent, or reflective film) up to 0.25 mm in thickness
(excluding high-luminosity reflective film)
Interfaces RS-232C/USB (Full Speed)
Buffer capacity 2 MB
Command modes
GP-GL, HP-GL
TM *2
(selected on the control panel)
Display panel Liquid crystal display (16 characters x 1 row)
Rated power supply 100 to 240 V AC, 50/60 Hz
Power consumption 100 VA
Operating environment 10°C to 35°C, 35% to 75% RH
Conditions for guaranteed precision
16°C to 32°C, 35% to 70% RH
External dimensions (W x D x H)
Approx.
623 x 285 x 223 mm
Approx.
851 x 585 x 1004 mm
*3
Approx.
1,487 x 744 x 1194 mm
*3
Weight Approx. 9.4 kg
Approx. 25 kg
*3
Approx. 39.1 kg
*3
*1: Varies depending on the type of Graphtec-authorized film and the cutting conditions
*2: HP-GL
TM
is a registered trademark of Hewlett-Packard Company.
*3: Including the stand
To Next Page
Loading...
