GRAPHTEC CE5000-40CRP - How to Replace the Y-Belt

CE5000-UM-251-9370 6-22
6. DISASSEMBLY AND REASSEMBLY
6.2.10 How to Replace the Y-belt
How to detach the Y-belt
(1) Detach the right and left side covers (see Subsection 6.1.1 and Subsection 6.1.2).
(2) Detach the center cover (see Subsection 6.1.3 or 6.1.4).
(3) Detach the pen block (see Subsection 6.2.5).
(4) Loosen the M3L6 TP head screw attaching the Y-tension arm.
(5) Push the Y-tension arm in the direction of the arrow as shown below, then detach the Y-tension spring
hook from the left side plate.
M3L6 TP head screw
Y-tension bracket
Y-tension arm
Y-tension spring
(6) Remove the four M3L6 binding head screws attaching the right and left Y-belt stopper plates to the
slider.
Y-belt
Y-slider
Y-belt stopper plate
M3L6 binding head screw
(7) Detach the Y-belt from the unit.