CE5000-UM-251-9370 6-17
6. DISASSEMBLY AND REASSEMBLY
6.2.6 How to Replace the Push Roller Sensor
How to detach the push roller sensor
(1) Detach the center cover (see Subsection 6.1.3 or 6.1.4).
(2) Detach the pen block (see Subsection 6.2.5).
(3) Disconnect the push roller sensor fl exible cable from the Y-relay board.
(4) Remove the push roller sensor fl exible cable that is attached with double-sided adhesive tape to the
Y-slider.
(5) Remove the M3L6 binding head screw attaching the push roller sensor bracket to the slider.
Y-slider
M3L6 binding
head screw
Push roller sensor board
Push roller sensor bracket
(6) Remove the M3L6 binding head screw attaching the push roller sensor board.
(7) Disconnect the push roller sensor fl exible cable from the push roller sensor board.
How to reinstall the push roller sensor
(1) Attach the push roller sensor bracket to the push roller sensor board.
(2) Connect the push roller sensor fl exible cable to the push roller sensor board.
(3) Attach the push roller sensor bracket to the Y-slider.
Fit the top and left edges of the push roller sensor bracket to the Y-slider as shown in the fi gure below.
Push roller sensor bracket
(4) Attach the pen block (see Subsection 6.2.5).
(5) Reattach the other parts in the reverse order in which they were detached.
To Next Page
Loading...
